Large chandeliers are installed on the structural layers, such as slabs, trusses and beams on the trusses. Small chandeliers are often installed on the shed or on the reinforcement joists. Whether a single chandelier or a combination chandelier is produced by the luminaire factory, The difference is that a single chandelier can be installed directly, and the chandeliers must be combined after installation or installation. For large-area and strip-shaped lighting, the use of suspension rods and light holders is often used.
Installation precautions: Pay attention to the following three points during installation and construction.
1. If there are multiple chandeliers during installation, pay attention to their position and length. Install the chandelier at the same time as installing the ceiling. This can adjust the position and height of the lamp based on the ceiling joists.
2. The method of direct exit and casing can be used for the ceiling of the boom. The method of adding the pipe is advantageous for the installation, and the roof panel can be ensured to be complete, and only the hole where the pipe is required to be taken out can be drilled. Straight out of the ceiling of the hanging cup, the drilling of the board surface is not easy to find. Sometimes it is possible to install the boom first and then cut off the panel to install the hole, but it has an effect on the decorative effect.
3. The boom should have a certain length of thread, in order to adjust the height. Suspend the light box below the sling boom, pay attention to the reliability of the connection.
